Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[HELP] Power a x86 pixo-itx board

Status
Not open for further replies.
T

TSC21

Newbie level 3
Joined
Sep 6, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,301
Hi there,

I'm building an RC/robotics project where I need to power a pico-itx board with a 12V 5A power source. All of the system (board+motors) is powered by a 5000mah 6C lipo battery so I need a dc-dc voltage stabilizer/converter. I found this one in Ebay: **broken link removed**
Is this module considered safe for the system? If not, can you please recommend me an alternative?

Thanks! Best regards,
TSC
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top