Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

"Advanced Design System" help

Status
Not open for further replies.

zgq0319

Newbie level 4
Joined
Nov 26, 2004
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
76
hi all! i am a "Advanced Design System " beginer.i don't know how to start my first course,if someone knows something about it,please! please!give me some suggestion.thanks a lot.
 

this is a basic pdf document about @ds
 

no shorcuts.
see ADS help document which should be enough for you.
 

i have pdf about ads2002
 

I have a question , when I make match network by ADS ,the result is different from the practical test by Network analyzer . Any guys could tell me the reason ? Best regards !
 

Hi,

I face the same problem... up to 10% frequency drift sometimes...

I think this could this be due to:
1. Fab tolerance?
2. Accuracy of simulation?
3. Parasitics at the vias etc that was not considered?

I'm new to this area, it'll be good if someone can give me a few pointers :)
 

u can try also to use design Guide it is quit usefull
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top