Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

L293d motor driver output

Status
Not open for further replies.
D

deepak1993

Newbie level 1
Joined
Jan 6, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,286
plz help me,i m using L293d ic to drive 12V dc geared motor , but i m getting very low output voltage of only 1.5V , even in input voltage i give 12V
n digital input by microcontroller ,so plz tell me how to get 12V at otput
 

deepak1993 said:
plz help me,i m using L293d ic to drive 12V dc geared motor , but i m getting very low output voltage of only 1.5V , even in input voltage i give 12V
n digital input by microcontroller ,so plz tell me how to get 12V at otput
Click to expand...

Check your schematic. Ensure the Enable pin of the respective bridge is high. Ensure the pin 8 is connected to 12V and ensure your using the right logic to run the motor.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top