Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Eagle Pro:......making copper pour go "transparent"

Status
Not open for further replies.
T

treez

Guest
Hello,

Do you know how to make a copper pour go transparent in eagle pro?

i eventually found out how to fill in the polygon, but occasionally i want it to be see-through....do you know how to do this?
 

I think it is RIPUP @;

I cannot check at the moment.

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Option 1. chose "info" toolbar and click on the side/corner of polygon to change the name of it. chose whatever you want. and the save it and when you want to see it again change the name again.
Option 2. you can use the delete button to deleted the polygon.
Option 3. Close your project and then open it again copper pour wont be visible at first you have to click ratsnet to show it!
Regards
Punit
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top