Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

2.8 inch LCD mtf0280qn - 18 interface

Status
Not open for further replies.

shreyas_patel21

Full Member level 3
Joined
Jan 4, 2011
Messages
181
Helped
15
Reputation
30
Reaction score
14
Trophy points
1,298
Activity points
2,325
I am using 2.8 inch LCD mtf0280qn with NIOS II processor.

the LCD uses HX8347D driver IC,

datasheet of this driver IC tells that it can be configure as 8 bit parallel or 16 bit parallel interface or many other by connecting pins IM0, IM1, IM2, and IM3 to VCC or ground,

but I have no any pins available at interface header strip. it has 37 pins as shown in mtf0280QN datasheet.

how can I know the interface of the LCD i.e. 8 bit parallel or 16-bit parallel?

thank you,

regards,
shreyas.
 

I asked the manufacturer of LCD and as per their suggestion they told me that LCD is configured as 8-bit parallel by them.

now I tried the code to read the driver ID of LCD and as per HX8347-D datasheet it should be read as 0x47, but I am getting 0x00.

what may be the problem? can it be a problem of reset?
if reset is not done properly, cant we read driver ID?

any suggestion will be helpful

thanks & regards,
shreyas.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top