Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all, I'm new on this field, and if someone can help me to simulate Digital thermostat on Proteus with LM35 sensor, and write code in assembly language, thank you
LM35 gives an analog output. It outputs 10mV per degree Celsius. You will need an ADC (analog to digital converter) to interface the LM35 to the microcontroller. Few 8051 microcontrollers I know of have an on-chip ADC. So, you may need to use an external ADC such as 0804.
For interfacing LM35 with 89S52 using ADC0804 check here: **broken link removed**
If LM35 is not a strict requirement, you can use a sensor like DS18S20 to interface directly with the microcontroller without the need to use an ADC.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.