munzir
Full Member level 6
My donkey water supply pump when i start it to run it stuck and don't run as i rotate the (part on which belts are seated and is connected to the shaft i.e. rotor and to the piston) by hand then it starts to rotate (run) but is making strange sounds while running as if there's some mechanical issue whether in the piston or bearings (if any of the bearings are there inside it , i don't know about the bearings inside it).
To understand the term donkey water supply pump , i'm attaching its images
https://obrazki.elektroda.pl/8842117900_1351458304.jpg
https://obrazki.elektroda.pl/5612783200_1351458305.jpg
https://obrazki.elektroda.pl/8149409000_1351458305.jpg
https://obrazki.elektroda.pl/1616995600_1351458306.jpg
thanks
take care
best regards
To understand the term donkey water supply pump , i'm attaching its images
https://obrazki.elektroda.pl/8842117900_1351458304.jpg
https://obrazki.elektroda.pl/5612783200_1351458305.jpg
https://obrazki.elektroda.pl/8149409000_1351458305.jpg
https://obrazki.elektroda.pl/1616995600_1351458306.jpg
thanks
take care
best regards