Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Draw rectangle which touches both antenna arms.
right click on rectangle->assign excitation->lumped port
in integration line->new line
go to middle point of one arm side of rectangle. It'll show a triangle. Click on it and go to opposite side. Find another triangle and click.
P.S: triangle will show up only when you reach mid point.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
