Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Please advice me for the following

Status
Not open for further replies.
PA3040

PA3040

Advanced Member level 3
Joined
Aug 1, 2011
Messages
883
Helped
43
Reputation
88
Reaction score
43
Trophy points
1,308
Activity points
6,936
Dear All,
I am new for this area therefore please kindly advice me for the following

FR4 TG135?
1/1oz?
HASL?
1.6mm? I think this is thickness of the PCB
I am using Sprint layout 5 for designing

Thanks in advance
 

FR4 is the standard fibreglass-epoxy base for general use PCBs.
TG135 is the 'Glass Transition' temperature (135°C) - above this the board softens.
1/1oz means 1oz of copper per square foot (that's 34.8µm thick), double sided
HASL is Hot Air Solder Levelling: The etched PCB is dipped in molten solder and the excess is levelled (blown off) by hot air jets.
1.6mm is the thicckness (standard for single and double sided)
 
  • Like
Reactions: PA3040

    PA3040

    PA3040

    Points: 2
    Helpful Answer Positive Rating
Dear Foxy,
Thanks for the reply

Could you please explain bit more on FR4 stranded

Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top