kunal123
Advanced Member level 4
hello,
i facing problen while uploading sketch in arduino uno r3 using arduino1.0 IDE, uploading complete i get Done uploading with following message
System wide configuration file is "C:\Users\kunalk\Desktop\arduino\arduino-1.0-windows\arduino-1.0\hardware/tools/avr/etc/avrdude.conf"
Using Port : \\.\COM4
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude done. Thank you.
can someone suggest me solution for these error
thanks
i facing problen while uploading sketch in arduino uno r3 using arduino1.0 IDE, uploading complete i get Done uploading with following message
System wide configuration file is "C:\Users\kunalk\Desktop\arduino\arduino-1.0-windows\arduino-1.0\hardware/tools/avr/etc/avrdude.conf"
Using Port : \\.\COM4
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude done. Thank you.
can someone suggest me solution for these error
thanks