Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

cadence assura DRC error

Status
Not open for further replies.
A

ali kotb

Member level 3
Joined
Feb 11, 2012
Messages
61
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,732
hii , I am new to layout . I use assure for DRC checks , and I have an error :
"PP.EN.2 3 enclosure of PW strap >=0.03 "
I only used OD (oxide diffusion ) on the layout editor , and th error came by .

Plz help me in resolving this ,
thnx
 

Looks to me like you need at least 0.03 overlap of PP past the diffusion edge. PP probably being P-Plus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top