Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What happens to the insulator, if it is under the influence of high frequency ?

Status
Not open for further replies.

pateldivyesh68@gmail.com

Member level 3
Joined
Mar 21, 2011
Messages
54
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,615
what happens to the insulator, if it is under the influence of high frequency ?
thank you so much....!:|
 

Re: problem on insulator

It depends on the dissipation factor of the dielectric. Every insulator acts as a capacitor so if the dielectric is lossy to RF, there will be heat generated which will cause the insulator to break down.
Frank
 

Re: problem on insulator

When the insulator has uniform structure and the field is uniform also, you only need to consider additional dissipation due to the higher loss per volume (dielectric loss). Note that with increasing temperature, dielectric strength reduces.

When field distribution is far from uniform and/or insulation is non-uniform and dielectric strength is also non-uniform across the insulation, it becomes more elaborate. Think of insulation with air voids or contaminants, or cable insulation where there is air between the insulated wires making up the cable.

Here partial discharge (within solid insulation, in air, or over surface) may dominate the design process. Partial discharge (PD) may erode the insulation resulting in failure. The voltage where partial discharge stops (PD extinction voltage) drops with increasing frequency (compared to 50/60 Hz). A transient signal/pulse may initiate PD and that PD can be maintained by the working voltage.

If your question is related to safety insulation, you may try to get IEC 60664-4 or a product safety standard that incorporates partial discharge at > 30 kHz.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top