Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Low power single ended tube amplifier

Status
Not open for further replies.

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


It is a low power single ended tube amplifier of own construction. The device was based on Soviet tubes: 6n2p in preamplifier and 2x 6p14p in the power amplifier. The amplifier operates in triode mode. Transformers tg2,5/1/666 were used in this project. The amplifier was assumed to have approximately 2W per channel. Transformer TS50.

Specification:
  • PRI: 230
  • Sec:
    1. 220V/120mA
    2. 6,3V/2,5A

Schematic:



Housing and chassis:
Housing was adapted to the device by cutting out the front and sanding, then painted with a lacquer. Front and top are made of 2mm aluminum sheet, also sanded and painted with a golden spray. Speakers terminal, IEC socket and a fuse are on the back. On the front, you can see input, volume control, anode voltage (blue switch) and glow (red switch).



Power supply:
The power supply was designed on a PCB. At the input behind the first capacitor there is about 305V.
Filtering consists of:
  • 3x 100uF/400V
  • 2x 47uF/400V
  • 1x 100nF/400V
  • 1x 470nF/400V
  • resistors 5W
  • bridge 6A

There is also a safety button, which is a plus shorted to the ground by 110kR. When you want to change anything, just discharge the capacitors using that.



Assembly and run:
Front is connected to the ground via a socket. Top, when it is screwed, shorts to the front and shields the whole device.
Glow is symmetrized to the ground via 100ohm resistors.




Link to original thread - Wzmacniacz lampowy małej mocy
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top