Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Number of vias affects cost of pcb to manufacture?

Status
Not open for further replies.
G

grizedale

Advanced Member level 3
Joined
Jun 13, 2011
Messages
838
Helped
17
Reputation
34
Reaction score
17
Trophy points
1,298
Activity points
8,804
Supposing i have twenty 0.6mm vias in my double sided pcb.........then suppose i add 20 more of exactly the same size.

Am i right in saying that that the increased number of vias will not increase the cost of the board at all?
 

ive never heard of galvanised vias.

Surely its obvious that the number of vias doesnt matter as long as theyre the same size?

After all, its just a single drill which gets plonked repeatedly over the board?
 

My post evaporate. :shock:

I saw two my identical post, I dont know how this happen, and I try to delete one of them, after then both posts are deleted.


blind-vias-pcb-599.jpg


0.jpg
 
Last edited:
thanks, they look high current rated vias
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top