Munib
Advanced Member level 4
A reference design 4 an evaluation board of CC1010(RF tranceiver+mcu)
is given at
**broken link removed**
This contains schematic and layout files
different file extensions are: *.spl , *.pcb , *.cpa , *.scm , *.usr , *.rep
Now i have some questions regarding this:
1) which software can be used to open and/or modify these files?
2)is it possible to use Orcad for question 1
3)are these files r enough to send to a pcb manufaturer to get pcb
manufactured?
4)if answer to Queastion 3 is yes then which files to send to manufacturer
for pcb fabrication?
5)is there any file which could be given to assemler to get different components mounted on PCB?
6)can anybody tell me some PCB manufacturer in India,Pakistan or China to get this 4 layer PCB fabricated
7) if possible plz tell me rough estimate for cost
Plz use the above given link to have a look at the files
And PLZZZZZ give answers to as many questions as u can because this is my final year project and i have not much time
is given at
**broken link removed**
This contains schematic and layout files
different file extensions are: *.spl , *.pcb , *.cpa , *.scm , *.usr , *.rep
Now i have some questions regarding this:
1) which software can be used to open and/or modify these files?
2)is it possible to use Orcad for question 1
3)are these files r enough to send to a pcb manufaturer to get pcb
manufactured?
4)if answer to Queastion 3 is yes then which files to send to manufacturer
for pcb fabrication?
5)is there any file which could be given to assemler to get different components mounted on PCB?
6)can anybody tell me some PCB manufacturer in India,Pakistan or China to get this 4 layer PCB fabricated
7) if possible plz tell me rough estimate for cost
Plz use the above given link to have a look at the files
And PLZZZZZ give answers to as many questions as u can because this is my final year project and i have not much time
Last edited by a moderator: