SPI EEPROM(X25128P) interface problem with atmega8

Code C - [expand]
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
sbit Chip_Select at PORTB0_bit;
sbit Chip_Select_Direction at DDB0_bit;
 
unsigned int buffer=0,value=0;
 
void Init()
{
 
  DDRD=0xFF;
  PORTD=value;
  Chip_Select = 1;                        // Deselect DAC
  Chip_Select_Direction = 1;              // Set CS# pin as Output
  //SPI1_Init();                            // Initialize SPI1 module
  SPI1_Init_Advanced(_SPI_MASTER, _SPI_FCY_DIV64, _SPI_CLK_LO_LEADING);
  Delay_ms(2000);
}
 
void spi()
{
 
     chip_Select=0;           //write latch enable
     SPI1_write(0x06);      //enable write enable latch
     chip_Select=1;
     Delay_ms(10);
                              //write status register
     chip_Select=0;
     SPI1_write(0x01);    //instruction to write in the status register
     SPI1_write(0x02);
     chip_Select=1;
     Delay_ms(10);
     
     chip_Select=0;            //start of write operation
     SPI1_Write(0x02);       //instruction code to write in the EEPROM
     SPI1_Write(0xC001);   
     SPI1_write(0x04);
     chip_Select=1;
     
     Delay_ms(10);
     
     chip_Select=0;           //start of read operation
     SPI1_Write(0x03);      //instruction code to read in the EEPROM
     SPI1_write(0xC001);
     value=SPI1_Read(buffer);
     chip_Select=1;
     PORTD=value;
}
 
void main() 
{
  Init();
 
  while (1)
   {
    Delay_ms(1000);
    spi();
  }
}