Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Incremental Reference Designator update in Allegro HDL entry 16.3

Status
Not open for further replies.
N

niks

Full Member level 3
Joined
Mar 18, 2002
Messages
189
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
1,386
How to do Incremental Reference Designator update in Allegro HDL entry 16.3?
For example I have resistors from R1 to R50, few of them deleted during design cycle. Now I add 2 more resistors in design. After back-annotating design new resistors gets missing references (say R20, R21) instead incremental value R51 and R52.
How to overcome on this issue?
 

abhi_tandon80 said:
export physical ---> repackage ----> From layout ---->annotate
Click to expand...

This will reset all old reference designator. I want to preserve all old reference designators.
When I add new resistor then it should start incrementing from highest reference of resisitor.
 

you can put $ before Location to fix Ref des so that they will not change
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top