Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

current handling and sheet resistance of a metal layer

Status
Not open for further replies.
M

mvvijay78

Member level 4
Joined
Oct 31, 2001
Messages
74
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
499
Hi,
If we are using a 0.18u TSMC library does the library file have the spec for the current handling capability of a layer in A/m and also the sheet resistance so that we can do the manual calculation of the IR drop.If no then where do i get this info from?
 

I think there will be a introduction of the current density in TSMC's design rule, PCM , and relevant doc.
 

Hi mvvijay78,

For 0.18um TSMC process, you can get the current density details from the Design Rule Document. The Sheet Resistance details are present in the Spice Document.

-Sudhir
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top