Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

autostop "sweep" in hspice

Status
Not open for further replies.
U

ucs

Newbie level 4
Joined
May 11, 2012
Messages
6
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,326
hello! Does anyone know how to stop the sweep simulation in hspice? e.g. ".tran 1n 10m sweep volt 1 10 0.1 .measure…………" When the value of volt sweep to 4v,my .measure statement has finished its task,so i want the value of volt in the .tran statement to stop from sweeping to next value,i.e.,4.1v.but i don't know how to do this.can anyone do me a favor?Thanks a lot!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top