Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[Synopsys vcs] Segmentation fault when running ./simv

Status
Not open for further replies.
V

Vonn

Full Member level 4
Joined
Oct 6, 2002
Messages
230
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,298
Activity points
2,458
Hello,

I am trying to use Synopsys vcs to compile and simulate a simple vhdl design. vhdlan and vcs worked fine but I am now getting a "Segmentation fault" error message when I run %./simv to simulate my design

I noticed that the tool gives me the following warning at the beginning

Warning-[LNX_OS_VERUN] Unsupported Linux version
Linux version 'Scientific Linux release 6.2 (Carbon)' is not supported on
'x86_64' officially, assuming linux compatibility by default. Set
VCS_ARCH_OVERRIDE to linux or suse32 to override.
Please refer to release notes for information on supported platforms.

could this be the problem? I am just not sure because vhdlan and vcs worked fine.

Thanks,
Vonn
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top