Munib
Advanced Member level 4
hi
i m doing a project on wireless sensor networks.i m using chipcons cc1010(i.e mcu+RF tranceiver in single chip).the frequency i m using is 433MHz.The reference design given by chipcon has four layers.Layer 1 has general ICs.Layer 2 is a ground plane, Layer 3 is power plane.layer 4 has an inductor and some routing
Now problem is that in my country we have no facility available for fabrication of 4 layer pcb. we can fabricate pcb of 2 layers
i m thinking to have all ICs and routing on layer 1 and all the ground and power lines combined on layer 2
question will this thing work especially with reference to 433 MHz and is there any other good solution to this problem
and any other special considerations for PCB layout
Thanking in anticipation
Regards
Munib
i m doing a project on wireless sensor networks.i m using chipcons cc1010(i.e mcu+RF tranceiver in single chip).the frequency i m using is 433MHz.The reference design given by chipcon has four layers.Layer 1 has general ICs.Layer 2 is a ground plane, Layer 3 is power plane.layer 4 has an inductor and some routing
Now problem is that in my country we have no facility available for fabrication of 4 layer pcb. we can fabricate pcb of 2 layers
i m thinking to have all ICs and routing on layer 1 and all the ground and power lines combined on layer 2
question will this thing work especially with reference to 433 MHz and is there any other good solution to this problem
and any other special considerations for PCB layout
Thanking in anticipation
Regards
Munib