marmaduque
Newbie level 1
Hi Everyone,
I am simulating a single balance mixer in Cadence using QPSS. When plotting the IIP3, I don't obtain a 3:1 slope as expected, but a slope much lower. This issue is mentioned in the following thread but there are no further comments on it: https://www.edaboard.com/threads/25014/
Has anyone had s imilar issue and knows the causes? I suspect it has to do with the PORT sources but I'm still not sure what it could be...
Thanks in advance!
I am simulating a single balance mixer in Cadence using QPSS. When plotting the IIP3, I don't obtain a 3:1 slope as expected, but a slope much lower. This issue is mentioned in the following thread but there are no further comments on it: https://www.edaboard.com/threads/25014/
Has anyone had s imilar issue and knows the causes? I suspect it has to do with the PORT sources but I'm still not sure what it could be...
Thanks in advance!