marmota77
Newbie level 2
Hi everyone,
I have a more than probable naive question. The point is that I'm new to Allegro, but in the past I had a lot of experience with Cadstar and Eagle.
I have a very simple design in my hands and just want to know from the PCB editor which is the drill hole size of a pad in a thru-hole component. Something that is rather simple to extract/display in other tools doesn't seem to be so straightforward with Allegro... or maybe I've just lost my bearings... I've been struggling for hours and no way.
Any help is more than welcome.
Kind regards.
I have a more than probable naive question. The point is that I'm new to Allegro, but in the past I had a lot of experience with Cadstar and Eagle.
I have a very simple design in my hands and just want to know from the PCB editor which is the drill hole size of a pad in a thru-hole component. Something that is rather simple to extract/display in other tools doesn't seem to be so straightforward with Allegro... or maybe I've just lost my bearings... I've been struggling for hours and no way.
Any help is more than welcome.
Kind regards.