Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
AFAIR all measurements of an analysis go to the .mt0 file. If you add an .alter statement and then more .meas statements, they'll be reported to an .mt1 file -- and so on. But I don't remember if you need to run a new analysis after the .alter statement for that.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.