Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to turn off Calibre warnings?

Status
Not open for further replies.
A

allanvv

Advanced Member level 4
Joined
Oct 23, 2010
Messages
108
Helped
14
Reputation
28
Reaction score
12
Trophy points
1,298
Location
USA
Activity points
2,078
Everytime I run Calibre for DRC I get around 50000 warnings like this:

Cell name parameter <blah> for INSIDE CELL operation not located.

How do I suppress these warnings?
 

As far as I know, you can not suppress these warning message from externally. This warning message is reported because Calibre does not find the CELL NAME used in operation in your layout. If you have write access to Calibre runset, then you can add an exception in starting of Calibre. You can refer to Mentor user manual for more details.

Thanks.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top