Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Regarding fault & Defect

Status
Not open for further replies.

pavanhs

Junior Member level 2
Joined
Jul 5, 2011
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,409
Hi,

What is the difference between Fault and a Defect ?


Thanks in Advance,
Pavankumar HS
 

Defects refer to physical malfunction errors like Short-circuited Source/Drain, PG shorts, open interconnects etc.
Faults are modeling defects as logical/timing failures like STUCK at 0/1 fault or STUCK OPEN fault.
 
Hi nisshith,

So what is the difference b/n STUCK at 0/1 or STUCK OPEN fault.


--
Thanks
Pavan HS
 

Stuck AT means ur port has either got connected to VDD or GND and STUCK Open means there is break in wire
 

Thanks for the quick reply,

But Stuck AT also we do for nodes(wires) whether they are connected to VDD or GND rite??
 

Yes,
why would we check STUCK AT those are supposed to be connected to VDD/VSS.
We do check for all nodes which by mistake got connected to VDD/VSS
 

Can u please briefly elaborate me the difference between Stuck at and Stuck Open??
Basically im not getting the difference b/n wire and node(port).

stuck-at--->port(or)node(or)wires ?
stuck-open--->wire ?
 

Stuck AT --> NODE (point where multiple nets/pins are connected) tied to VDD/VSS
STUCK OPEN --> breaks in WIRE
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top