how to analyze the change of transmission direction for transmission line using Mw eq

How to analyze the change of transmission direction for transmission line using Maxwell eqation?

When the transmission line bend (e.g. mircostrip routing change direction ), how to analyze using Maxwell eqation?

let us discuss this interesting question.
I have never find related discussion.

There are some paper references at the bottom of this page:
**broken link removed**

• M. Kirschning, R. H. Jansen, and N. H. L. Koster. "Measurement and Computer-Aided Modeling of Microstrip Discontinuities by an Improved Resonator Method," 1983 IEEE MTT-S International Microwave Symposium Digest, May 1983, pp. 495-497.
• R. H. Jansen, "Probleme des Entwarfs und der Messtechnik von Planaren Schaltungen," 1. Teil, NTZ, Vol 34, July 1981, pp. 412-417.
• E. Hammerstad and O. Jensen, "Accurate Models for Microstrip Computer-Aided Design," MTT Symposium Digest, 1980, pp. 407-409.
• K. C. Gupta, R. Garg, and R. Chadha, Computer-Aided Design of Microwave Circuits, 1981, p. 195.

volker_muehlhaus said:

There are some paper references at the bottom of this page:
**broken link removed**

• M. Kirschning, R. H. Jansen, and N. H. L. Koster. "Measurement and Computer-Aided Modeling of Microstrip Discontinuities by an Improved Resonator Method," 1983 IEEE MTT-S International Microwave Symposium Digest, May 1983, pp. 495-497.
• R. H. Jansen, "Probleme des Entwarfs und der Messtechnik von Planaren Schaltungen," 1. Teil, NTZ, Vol 34, July 1981, pp. 412-417.
• E. Hammerstad and O. Jensen, "Accurate Models for Microstrip Computer-Aided Design," MTT Symposium Digest, 1980, pp. 407-409.
• K. C. Gupta, R. Garg, and R. Chadha, Computer-Aided Design of Microwave Circuits, 1981, p. 195.

Click to expand...

that is from the circuit view.
what about the Maxwell's equations?

Some previous post seem to be lost !?

I had replied that applied Maxwell's Equations = EM solvers are used to calculate bend elements since more than 20 years. Some circuit simulators like AWR Microwave Office let you choose if you want to use the fast, equivalent circuit model based approach or an "on the fly" EM extraction of the bend layout.

I am not sure what your new approach is about?