Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

12-15V 8A Power Supply Design Using ATX supply componenets

Status
Not open for further replies.

saeed_pk

Full Member level 4
Joined
May 20, 2006
Messages
237
Helped
35
Reputation
68
Reaction score
28
Trophy points
1,308
Location
Islamabad, Pakistan
Activity points
2,655
Dear All
I have ATX Supply i want to re-design it but using same flyback transformers i can use any MCU/etc but i can't change inductors. and I only want one output 12~15V DC (Controllable)

please advice
 

Hello Dear saeed
what do you need clearly ? do you need a way for inductor calculation ? or do you need calculations of a fly back converter ? or you just need a circuit ?
By the way , how much is the value of your maximum out put current ?
Bes Wishes
Goldsmith
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top