Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Angle grinder as a small table saw

Status
Not open for further replies.

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


The device is excellent for quick and precise cutting laminates for PCB. Stands for angle grinders are not very convenient, because you can only cut materials of small size and they are not very precise (large clearances on hinges).
Angle grinder 500W 115mm disc diameter was used. 9mm thick plywood 250x400mm was the top. An oblong hole was cut with a straight grinder placed in the cradle for milling.
Steel blade was used to cut the laminate. Additionally, an external speed control was used, because without that the edges are burned (11000rpm is far too much). Visible in the last photo protruding long M6 screw is necessary to diverge the grinder, to set the angle between the blade and the top.



Link to original thread (useful attachment) – Szlifierka kątowa jako mała pilarka stołowa
 

Using an angle grinder to drive a circular saw blade is extremely dangerous. I will try to install a circular saw to the small table.



angle grinder
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top