Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Lumped components and a transistor in ads layout ?

Status
Not open for further replies.
D

deshpande.pratik

Junior Member level 3
Joined
Dec 26, 2011
Messages
30
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,447
My circuit has just lumped components and a transistor in the schematic.

How do i get about it in ads layout ?

Should i get it transferred in terms of tx lines, if so how ?

Kindly help me.
 

Hi,
can you explain me how did he get all the Tx lines by replacing the C's and the L's in the layout.

cause in the layout extra R's have been included.

Please help me with this.
 

Hello,

I think I have to leave the answer to someone who is more experiences with ADS layout.
Here is basic information that I have:

If you right click on the component, you can do Component > Edit Component Artwork. There, you can select "fixed" and in the dropdown list below, choose one of the existing layout defintions.

As an alternative, you can also use the "Lumped with Artwork" where you can define the pad size in the component defintion.
**broken link removed**

21_1325846341.png


As a third alternative, some components libraries also used "programmed" layout with the AEL macro language.
 

Thanks for the help.

This is my first time I am designing a layout so stuck with it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top