Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help me design a DC-AC inverter controlled by PWM

Status
Not open for further replies.

bctang

Junior Member level 2
Joined
Sep 4, 2004
Messages
23
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
293
PWM Control Inverter

Hi,

I need to design dc to ac inverter from DC +12Volt to AC 230. But i need to use PWM to control the inverter. I using "Sinusoidul Pulse Modulation" to control the MOSFET transistor.

When i using PWM to control the MOSFET transistor (inverter). The PWM signal will distortion. I have testing connect the AC load (lamp 230Vac/5W) , the output voltage from inverter drop to ~120Vac.

How to control or maintian the output voltage always 230Vac when connect AC-Load?
 

PWM Control Inverter

Is You inverter contain degenerative feedback circuit?

Are You use special h-bridge mosfet drive to control power mosfet (undervoltage protection & etc...)?
 
Re: PWM Control Inverter

goshka said:
Is You inverter contain degenerative feedback circuit?

Are You use special h-bridge mosfet drive to control power mosfet (undervoltage protection & etc...)?

I no understand "Is You inverter contain degenerative feedback circuit"?

I have using 2 mosfet (BSS89) drive to control my power mosfet.

Thank you..... :( :cry:
 
PWM Control Inverter

Are You use a negative feedback circuit for volage regulation?
 
PWM Control Inverter

at "Inverter Circuit.doc",Your Q5 D,S pole is reversal. you may chack it.
 

PWM Control Inverter

what ic did you used to generate the PWM signal??
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top