Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to read test patterns generated by TetraMAx

Status
Not open for further replies.
T

thanhFF

Junior Member level 2
Joined
May 14, 2010
Messages
22
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
australia
Activity points
1,451
I used Tetramax to generate test patterns for a full adder design. After finish, I showed the first pattern, and receive the following figure. I really dont understand how to read it. I thought a pattern contains a set of inputs. But here I see 3 bits for one input ????.

untitled.PNG

What do they mean here?
 

Hi thanhFF,

Check set pindata variable. U will find various options for it. The three bits which you are referring depends on this command. The three bits refer to preclock, clock and postclock data. U can find this information in the tetramax document.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top