Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Question about Lumped boundary condition in HFSS

Status
Not open for further replies.

ananth

Advanced Member level 4
Joined
Jun 29, 2004
Messages
113
Helped
56
Reputation
112
Reaction score
43
Trophy points
1,308
Location
India
Activity points
815
Lumped Boundary in HFSS

Hello everyone,
I am designing a power divider in HFSS and need to use a resistor for the same. Does the Lumped RLC boundary condition let me do something like this? I read the explanation in the tutorial and it does seem like the tutorial says that but wanted to make sure. Has anybody worked with this kind of thing before?
Ananth.
 

Re: Lumped Boundary in HFSS

To make it sure, use S-parameter block in a circuit simulator and connect it to the load you wish. Try to simulate in HFSS using boundary condition. See if they are the same.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top