poxkix
Member level 5
Specs:
16F877a @ 8Mhz crystal oscillator
MikroC compiler
Problem:
As usual before posting I searched the forum but none I can relate of.
The problem is, the lcd output is just jitter random values. Though, is my configuration correct?
Code:
16F877a @ 8Mhz crystal oscillator
MikroC compiler
Problem:
As usual before posting I searched the forum but none I can relate of.
The problem is, the lcd output is just jitter random values. Though, is my configuration correct?
Code:
Code:
// 0x02 = 0010
// 0x04 = 0100
// 0x08 = 1000
// 0x10 = 00010000
unsigned int i;
unsigned int s1, s2, s3, s4, s5;
char strS1[5], strS2[5], strS3[5], strS4[5], strS5[5];
void setUp() {
PORTB = 0;
TRISB = 0x01;
//ADCON1 = 0b0010;
TRISA = 0xFF;
ADCON1 = 0x80;
TRISC = 0x00;
i = 0;
}
void LCDconf() {
Lcd_Init(&PORTC);
Lcd_Cmd(Lcd_CLEAR);
Lcd_Cmd(Lcd_CURSOR_OFF);
}
void ADConf() {
s1 = Adc_Read(0);
s2 = Adc_Read(1);
s3 = Adc_Read(2);
s4 = Adc_Read(3);
s5 = Adc_Read(4);
IntToStr(s1, strS1);
Lcd_Out(1,1,strS1);
IntToStr(s2, strS2);
Lcd_Out(1,5,strS2);
IntToStr(s3, strS3);
Lcd_Out(2,1,strS3);
IntToStr(s4, strS4);
Lcd_Out(2,5,strS4);
IntToStr(s5, strS5);
Lcd_Out(1,1,strS5);
}
void main () {
setUp();
LCDconf();
//ADConf();
while(1) {
ADConf();
if(PORTB.f0==1) {
if(i==0) {
PORTB=0x04;
delay_ms(1000);
i=1;
} else if(i==1) {
PORTB=0x08;
delay_ms(1000);
i=2;
} else if(i==2) {
PORTB=0x10;
delay_ms(1000);
i=3;
} else if(i==3) {
PORTB=0x02;
delay_ms(1000);
i=0;
}
}
}
}