Specs:
16F877a @ 8Mhz crystal oscillator
MikroC compiler

Problem:
As usual before posting I searched the forum but none I can relate of.
The problem is, the lcd output is just jitter random values. Though, is my configuration correct?

Code:
Code:
// 0x02 = 0010
// 0x04 = 0100
// 0x08 = 1000
// 0x10 = 00010000

unsigned int i;
unsigned int s1, s2, s3, s4, s5;
char strS1[5], strS2[5], strS3[5], strS4[5], strS5[5];

void setUp() {
     PORTB = 0;
     TRISB = 0x01;
     //ADCON1 = 0b0010;
     TRISA  = 0xFF;
     ADCON1 = 0x80;
     TRISC = 0x00;
     
     i = 0;
}

void LCDconf() {
     Lcd_Init(&PORTC);
     Lcd_Cmd(Lcd_CLEAR);
     Lcd_Cmd(Lcd_CURSOR_OFF);
}

void ADConf() {
              s1 = Adc_Read(0);
              s2 = Adc_Read(1);
              s3 = Adc_Read(2);
              s4 = Adc_Read(3);
              s5 = Adc_Read(4);

              IntToStr(s1, strS1);
              Lcd_Out(1,1,strS1);
              IntToStr(s2, strS2);
              Lcd_Out(1,5,strS2);
              IntToStr(s3, strS3);
              Lcd_Out(2,1,strS3);
              IntToStr(s4, strS4);
              Lcd_Out(2,5,strS4);
              IntToStr(s5, strS5);
              Lcd_Out(1,1,strS5);
     }

void main () {
     setUp();
     LCDconf();
     //ADConf();
     
     while(1) {
              ADConf();
              
              if(PORTB.f0==1) {
                if(i==0) {
                  PORTB=0x04;
                  delay_ms(1000);
                  i=1;
                } else if(i==1) {
                    PORTB=0x08;
                    delay_ms(1000);
                    i=2;
                    } else if(i==2) {
                        PORTB=0x10;
                        delay_ms(1000);
                        i=3;
                        } else if(i==3) {
                            PORTB=0x02;
                            delay_ms(1000);
                            i=0;
                            }
              }
     }
}