Prakash Rajolli
Newbie level 6
Hello,
I am downloading the program on LPC1768 target board using CoiNel
ARM-USB-JTAG through Keil micro-vision 4.03. After programming, target
board going to reset mode. The programmed code will work only after
unplug the USB cable which is connected to the CoiNel ARM-USB-JTAG.
Is there any setting have to do on Keil IDE?
Many thanks in advance.
I am downloading the program on LPC1768 target board using CoiNel
ARM-USB-JTAG through Keil micro-vision 4.03. After programming, target
board going to reset mode. The programmed code will work only after
unplug the USB cable which is connected to the CoiNel ARM-USB-JTAG.
Is there any setting have to do on Keil IDE?
Many thanks in advance.