Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to add new signals to the end of signal list in ModelSim easily?

Status
Not open for further replies.
D

deathwaltz

Newbie level 4
Joined
Aug 2, 2010
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
yokohama
Activity points
1,321
Hi

When I try to look at the signals, I always add a new panel and then copy & paste the signals from the signal lists I created.
But there is a problem. I can't paste the signal to the end of signal list but the second to the list, i.e, I can only paste to the above of signal highlighted. Then I have to drag the signal to the end.

So is there any convenient way to add the signal directly to the end of signal list?

Thank you guys :-D
 
Last edited:

Hi deathwaltz,

You can copy the required signals to a " *.do " file. then call the " *.do " file when you need...

So you can add the signals at the end of other signal or above the signals as your wish...

So no need to create a separate panel and all.....
 
Hi imbichie,

Thank you for your reply.

That's a pretty good idea! :-D This solves the problem! Cheers!

Thank you again. :lol:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top