Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

A modeling and bike fridge compressor

Status
Not open for further replies.

rickyjar

Member level 2
Joined
Oct 20, 2009
Messages
52
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
2,032


User jajen” presents a fridge compressor. All the modifications can be seen in the photos below. The compressor has an automatic pressure switch operating within 3-5 bar, pressure protection in the case of jamming the switch (safety valve), regulator for the aerograph. The compressor has two outputs – one directly from the pressure tank and serves to pump bike tubes or as a blow, other one behind the regulator for the aerograph. The compressor works very quietly and has been serving very well for 2 years.



Link to original thread - Kompresor lodówkowy modelarski i do roweru
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top