Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to know parameters of unknown ferrite ring?

Status
Not open for further replies.
ALERTLINKS

ALERTLINKS

Advanced Member level 4
Joined
Dec 13, 2003
Messages
1,258
Helped
396
Reputation
786
Reaction score
380
Trophy points
1,363
Location
Pakistan
Activity points
7,263
24_1315745216.jpg

54_1315745216.jpg


I have bought few ferrite rings for car booster power supply or to use in class d amp output filter. But as data is not available, how can i estimate about power ratings and max frequency, it can support.
Outside diameter is 2.9 cm. inside diameter is 2 cm. width is 0.7 cm.
 

if you know the manufacturer of the bought ferrite rings , you can get the max power and frequency details.

otherwise , it is a difficult guesstimate for ferrites.
 

Hi,
I am sure you will be knowing it.
If it is not a BULK LOT PURCHASE by the local seller, their is always part number on the packingFerrite.JPG
And if you purchased it fro HALL ROAD, then :-D
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top