Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Vibration Problem of Temperature Test Chamber

Status
Not open for further replies.

technoqwerty123

Junior Member level 1
Joined
Aug 22, 2011
Messages
17
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,283
Activity points
1,388
Hello,
I am required to carry out an environment test in a temperature test chamber from -10 to 80 deg celcius. When in cooling mode the compressor makes the whole chamber to vibrate. My PCB and sensor setup is sensitive to these small vibrations. I thought about using a sponge for padding but it will get hard and loose its shock absorbing properties at low temperature. Any ideas that work at sub zero temparature?

Regards
 

it will depend on the soak time, if its not too long i dont think the cushion will freeze since it will be a cycle,i assume.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top