Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Does ADS momentum optimzation automatically modify port type?

Status
Not open for further replies.

ldynasa

Junior Member level 3
Joined
Jun 14, 2011
Messages
25
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,470
I'm wondering if ADS momentum optimizer would first turn port 1 into a single mode port while others ports into internal type while optimizing goals for S11.

I was configuring a impedance matching networks using momentum optimizer and the final result is always better if I used the above settings..:sad:
 

Only specific types of parameters could be optimized during optimization in momentum and definitely port type is not one of them. even you can not optimize dielectric permittivity during optimization in momentum.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top