Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

"uLCD-test" Atmega32, Siemens LCD, Bascom

Status
Not open for further replies.

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


Some time ago, a thread of a device on a display from Nokia appeared. This time Siemens cx70, c65 will be shown.

Preliminary information:
The device was designed to test Siemens displays and to use it in other devices.
It based on Atmega32L-8AU with Siemens cx70 display (with LS020B8UD06 driver). It uses a power supply of 12V tensity.
The board was designed in Eagle 5.10 and the program in Bascom.

Schema:


Functions working with the LCD display are in the program. There is a library to work with this LCD (search in the attachment of the original thread).
The PCB is designed to be the same size as the LCD.
To compensate the levels of tensions of the display and Atmega, a resistor divider was used.
All the device work pretty good, but it is recommended to change the 5V stabilizer from the SO8 housing to D-Pack. It is conditional on that the D-Pack can get 500mA of load and the SO8 only 100mA and in continuous work it's getting hot.

Construction:



Effect:



Link to video:

Another device like this:



How to determine the type of the display:

5859877700_1291721786_thumb.jpg


Some other things:
Nicely made power:








Link to original thread – "uLCD-test" Atmega32, Siemens LCD, Bascom
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top