Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Wiring 3.5 mm stereo headphone mountable jack socket

Status
Not open for further replies.
sanjubluerock3

sanjubluerock3

Full Member level 3
Joined
Sep 29, 2008
Messages
174
Helped
21
Reputation
42
Reaction score
18
Trophy points
1,298
Location
Bengaluru, India
Activity points
2,080

I drew two schematics ,
how to connect speakers and headphone plug

Use only one gnd-point for headphones,
in bridge amp. , find amplifiers real gnd point of power supply
( do not use speaker wire as gnd, it can kill your amp. stage )

Some amplifier needs 1W 100...220 ohm load resistor parallel to speaker

HeadPho_Bridg_Amp_speak.jpg HeadPho_Comm_gnd_speak.jpg

KAK
 

I answered this on your previous thread. I even gave you a nice link to the correct type of connector. What happened to that thread? Did you delete it and start over?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top