Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me with nonlinear simulation of ATF36077 in ADS

Status
Not open for further replies.
abdoeng

abdoeng

Advanced Member level 2
Joined
Feb 22, 2004
Messages
647
Helped
76
Reputation
152
Reaction score
63
Trophy points
1,308
Activity points
3,810
hi ads help pls

i have ads,is the nonlinear of atf36077 operate at 1.5 v,10 m amp,but i don't know the vgs,at all,can i use the two port text file that i make it,in the simulation in the nonlinear simulation,it has biasing differ from the actual nonlinear module of that amp.pls help what i use ,the nonlinear or the two port one module,thanks
 

Re: hi ads help pls

Hi abdoeng

Just put the Drain to ground, 1.5V on the Source, and Vary
the gate from -10V Up untill you get 10mA going through
the 1.5V supply. When you read 10mA you know that
that is the correct bias condition.

Cheers
 

hi @DS help pls

I use FET_CURVE_TRACER in template. Vgs for you bias point is about -0.250 Volts. The file I have attached is a zap file, you can try.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top