grizedale
Advanced Member level 3
Hello,
Do you know where I can source high-voltage , low-power 1 MegOhm resistors for paralleling with Y caps, which bridge the primary – to – secondary isolation barrier in an offline SMPS?
These resistors must withstand the 3500VAC HiPot isolation tester.
-Though I cannot find resistors that meet this voltage requirement.
-the purpose of these resistors is to allow leakage current to pass from secondary to primary, in order that the secondary side does not float up to dangerously high voltages.
Do you know where I can source high-voltage , low-power 1 MegOhm resistors for paralleling with Y caps, which bridge the primary – to – secondary isolation barrier in an offline SMPS?
These resistors must withstand the 3500VAC HiPot isolation tester.
-Though I cannot find resistors that meet this voltage requirement.
-the purpose of these resistors is to allow leakage current to pass from secondary to primary, in order that the secondary side does not float up to dangerously high voltages.
