Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

atmega 32 serial programmer

Status
Not open for further replies.
J

jayanthyk192

Full Member level 3
Joined
Sep 17, 2010
Messages
179
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Activity points
2,580
Hi,
i'm building a serial programmer for my atmega32.here's the link :Part III – Making Programmer and Target. | eXtreme Electronics

its not working with pony prog.i measured the voltage at reset pin which goes to zero when i select the read all option in pony prog.other than that nothing is happening and the device is not at all recognized by it.what should i do?
 

check out your connections. If you are using usb to serial converter it wont work.
 

I was actually using an extension cable that I had got with my p89v51rd2 programer.it had only 3 wires connected for serial data and gnd.(the mc had a boot loade).i just checked the connections and found the problem.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top