+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Full Member level 3
    Points: 1,698, Level: 9

    Join Date
    Sep 2010
    Posts
    179
    Helped
    1 / 1
    Points
    1,698
    Level
    9

    atmega 32 serial programmer

    Hi,
    i'm building a serial programmer for my atmega32.here's the link :Part III – Making Programmer and Target. | eXtreme Electronics

    its not working with pony prog.i measured the voltage at reset pin which goes to zero when i select the read all option in pony prog.other than that nothing is happening and the device is not at all recognized by it.what should i do?

    •   AltAdvertisment

        
       

  2. #2
    Advanced Member level 5
    Points: 13,695, Level: 28
    nandhu015's Avatar
    Join Date
    Feb 2006
    Location
    India
    Posts
    1,961
    Helped
    299 / 299
    Points
    13,695
    Level
    28
    Blog Entries
    18

    Re: atmega 32 serial programmer

    check out your connections. If you are using usb to serial converter it wont work.



    •   AltAdvertisment

        
       

  3. #3
    Full Member level 3
    Points: 1,698, Level: 9

    Join Date
    Sep 2010
    Posts
    179
    Helped
    1 / 1
    Points
    1,698
    Level
    9

    Re: atmega 32 serial programmer

    I was actually using an extension cable that I had got with my p89v51rd2 programer.it had only 3 wires connected for serial data and gnd.(the mc had a boot loade).i just checked the connections and found the problem.



--[[ ]]--