Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

several high level lobes before the input signal frequency for Delta Sigma Modulator

Status
Not open for further replies.
Y

yangyang10182

Newbie level 6
Joined
Feb 1, 2010
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,376
Hello guys,

I designed a first order delta sigma modulator in Cadence. And it is single bit. The frequency of the input signal is about 50Hz. The sampling frequency is 10KHz. I did the FFT for the output and got the spectrogram. But it looks not right. There are several lobes before 50Hz. And the signal level is much higher than the expected. I don't know what causes this problem.

I attached the spectrogram here. Hope someone can help me out. Thanks in advance!

 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top