Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How to simulate PLL loop filter noise by cadence spectre?
I used 3ord LPF in PLL.
As attached figure, dashed lines are resistors noise in LPF and solid lines are output noise after transfer function.
Who can help me about LPF noise simulation by cadence spectre.
thank you very much.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.