Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How can i pre-set-up enviroment of Spurious emission for FCC certification

Status
Not open for further replies.
T

ttkane

Newbie level 5
Joined
May 28, 2008
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,344
I'm interest in FCC Certification item
So i'd search some reference data from internet and reading some TIA603-C standard

Some question need clearly understand.
At testing for spurious emission needs 3m to 10m chamber site by radiation Method and some equipment set-up like as below picture.


How can i pre-test at laboratory by using conducted DUT method?
 

Attachments

  • chamber site.JPG
    chamber site.JPG
    26.3 KB · Views: 94

Do I need LPF or HPF Circuit to measurement full span at 10MHz to 10GHz
 

Perhaps if you explained what you mean by "conducted DUT method", we could answer you.
 

Thanks for your reply.
I hope my product could verify conducted spurious emissions in my laboratory.
How can i implement it??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top